Bench Mount Tungsten Grinder

Bench Mount Tungsten Grinder

Bench Grinder PPB Parts List
PPB-1 Motor PPB-1 Motor
PPB-2 Grinding Wheel PPB-2 Grinding Wheel
PPB-3 Back Mount PPB-3 Back Mount
PPB-3 Grinding Body PPB-3 Grinding Body
PPB-4 Dust Collector PPB-4 Dust Collector
PPB-5 Collector Knob PPB-5 Collector Knob
PPB-6 Locking Lever PPB-6 Locking Lever
PPB-7 Collet Knob PPB-7 Collet Knob
PPB-8 Sight Window PPB-8 Sight Window
PPB-9 Wheel Spacer PPB-9 Wheel Spacer
PPB-9 Wrench holder PPB-9 Wrench holder
PPB-11 Wrench Holder PPB-11 Wrench Holder
PPB-12 10-24 Screw PPB-12 10-24 Screw
PPB Collet PPB-1/16 1/16" Collet
PPB-3/32 3/32" Collet
PPB-1/8 1/8" Collet
PPB-5/32 5/32" Collet

Warning!
Always wear ANSI approved Dust Mak, Eye and Hand protection for grinding tungsten welding electrodes. And also read and understand operating instructions & parts manual.

  1. For ease of removing the dust collector it is best to mount the grinder on the side of your bench pedestal.
  2. Remove the appropriate collet from the collet holder, using the collet wrench.
  3. Install collet and tighten.
  4. Insert the tungsten electrode into the installed collet, loosen the locking lever and adjust the angle (a good starting point is where the electrode makes contact with the grinding wheel about center of the sight window). Tighten the locking lever and remove the electrode.
  5. Turn the grinder on and carefully insert the electrode and rotate the electrode at least 360 degrees making contact with the grinding wheel, repeat till the desired point is achieved.
  6. If flattening the electrode is desired, carefully insert the electrode into the flattening holes and rotate.
  7. Periodically check and properly dispose of the grinding dust.

Bench Mount Grinder